📜  dtb reverse (1)

📅  最后修改于: 2023-12-03 15:14:48.829000             🧑  作者: Mango

dtb reverse

Introduction

dtb reverse is a command-line tool designed to reverse a device tree binary file (.dtb file) into its corresponding Device Tree Source (DTS) file. This can be useful for debugging, editing and modifying device trees.

Installation

To install dtb reverse, you need to have Git and Python3 installed on your system. You can install dtb reverse by following these steps:

  1. Clone the dtb reverse repository using Git:
git clone https://github.com/vt-firmware/dt-utils.git
  1. Install the required Python packages using the following command:
pip3 install -r requirements.txt
Usage

To reverse a device tree binary file into a Device Tree Source (DTS) file, you need to use the dtb reverse command followed by the name of the binary file:

dtb reverse <binary_file.dtb> > <output_file.dts>

This command will reverse the binary file and output the resulting DTS code into the specified output file.

Markdown Example
### Installation

To install `dtb reverse`, please make sure you have `Git` and `Python 3` already installed. You can then follow the instructions below:

1. Clone the `dtb reverse` repository using Git:

git clone https://github.com/vt-firmware/dt-utils


2. Install the required Python packages via the terminal:

pip3 install -r requirements.txt


### Usage

For this example, I'll use `example.dtb` as my binary file and `example.dts` as the resulting output file.

To reverse a binary file into a Device Tree Source (DTS) file, use the command:

dtb reverse example.dtb > example.dts


The code block above should create the `example.dts` file in your working directory, containing the reversed DTS code.